Apply Vinyl Lettering Windex

Apply vinyl lettering to your surface lower the mask layer and using your squeegee press firmly at a 45 degree angle starting from the middle and going out.

Apply vinyl lettering windex.

Use a little rubbing alcohol to clean the area where the decal will be applied. Final note the application of this vinyl decal requires a degree of dexterity and concentration. If you re applying the decal to glass do not use windex or other ammonia based cleaners. Apply rubbing alcohol to remove any remaining oils or waxes from the vehicle s surface.

Only remove the wax paper when you are ready to apply the decal to prevent dirt from getting on the adhesive surface. Mild detergents or solvents can be used to remove wax grease tar etc. Spray the adhesive side of the decal with windex after or as you peel away the backing paper. With some elbow grease the adhesive can be removed.

Such as metal glass plastic wood wall board etc. Wipe away the excess windex and let the decals take a set. The ammonia interferes with the adhesive. If there are larger areas with the adhesive we recommend spraying the area with windex and with a soft cloth that will not scratch the vinyl clean the area.

Vinyl can be applied to any smooth surface. If you have never applied vinyl die cut decals it is recommend to do a little research online. Surface should be clean and dry before applying vinyl lettering. The adhesive on the back of the vinyl lettering should stick well to your surface if it has been properly cleaned and prepped.

They are all a little different but very helpful. This is key and it s a good time to walk away from the car. Whether you are applying a small decal such as a college sticker or parking permit or adhering a large rear window graphic choosing the right tools in the best weather conditions and taking plenty of time will assure effective decal application. How to apply vinyl lettering racing stripes vinyl stickers vinyl decals pinstripes and more.

Remove the wax paper. Peel off the wax paper using a friend to help with bigger decals. There are many youtube videos and websites that have great tutorials on how to apply vinyl die cut decals. The vinyl will not stick as well to any oil or waxy surface.

Glass cleaners such as windex can be used to remove dirt grit and water soluble substances. If air bubbles occur puncture with a pin and smooth down. Do not use windex in an aerosol can. Peel the backing paper from the decal.

Squeegee windex from under the decal beginning in the center and working outward. Get the best results when applying car window decals by following expert tips.